Forensic-computers Tableau T35i SATA/IDE Bridge Manual de usuario descargar pdf (Pagina 9)

SATA Det LED

The SATA Det LED (SATA Detect) illuminates when a hard disk attached

to the SATA interface connector has been properly recognized. Only one

hard disk may be connected to the T35i at a time.

IDE Det LED

The IDE Det LED (IDE Detect) illuminates when a hard disk attached to

the IDE interface connector has been properly recognized. Only one hard

disk may be connected to the T35i at a time.

Host Det LED

The Host Det LED (Host Detect) indicates when the connected hard disk

has been recognized by the host computer. The Host Detect LED will

illuminate only after the T35i has successfully identified a hard disk

connected to the front of the T35i and after the host computer has "logged

in" to the coresponding T35i channel using the FireWire/1394 SBP-2

protocol.

Wrt Blk LED

The Wrt Blk LED (Write Block) is illuminated whenever the Tableau bridge

is in READ-ONLY mode. This LED provides a positive indication that the

bridge may be used to capture a forensically sound image from a subject

hard disk.

Activity LED

The Activity LED indicates that the host is performing some kind of I/O

to the connected hard disk.

DC OUT Connector

The DC Out connector may be used to provide power from the Tableau

bridge to the subject hard disk. The DC Out output is controlled by the

power switch. So, using the DC Out connector guarantees that the drive

will be powered ON/OFF simultaneously with the T35i bridge.

Disk interface

Connectors (SATA and

IDE)

The disk interface connectors attach the subject hard disk to the T35i.

Tableau recommends the following cables:

Interface

Cable

SATA

TC3-8

IDE

TC6-8 or TC6-2

The next image is a rear view of the T35i. Captions identify each internal T35i connector and the

location of the configuration switches.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Forensic-computers Tableau T35i SATA/IDE Bridge Manual de usuario Pagina 9